1 / 11
The Black Hornet p2 - an addition to The Black Hornet p1 (soap bubble wand 10cm diameter)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
an addition to The Black Hornet p1 (soap bubble wand 10cm diameter)
- Rating
- 4 / 5
- Likes
- 35
- Downloads
- 176
- Makes
- 1
- Views
- 1,725
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution
This is “THE BLACK HORNET p2”an addition “THE BLACK HORNET p1”(a bubble wand with approx 10cm diameter)
The wand structure consists of four parts ( please refer to the colored picture above):
- Part One and Part Two - upper ring (green) and bottom ring (red)
the soap bubble fluid carrier ring, aka the upper (green) and the bottom (red) ring. Those two parts are glued together. In order to glue them together in a perfect way, there is an additional glueaid part (blue) included. - Part Three – the bow (yellow)
the bow was a nose at its bottom. This nose is sticked and glued into the glued ring pair. - Part Four – the handle (gray)
The handle is glued together with the bow at their overlapping areas (as shown in picture). The handle does have two holes, where you can glue in round 10mmx2mm magnets – those magnets are not necessary but very nice to fix “THE BLACK HORNET p2” onto the “THE BLACK HORNET p1” easily.

Some thoughts & hints:
- I recommend to print the bow upwards (nose aiming to the ground). This needs support, yes, but the outer surface is always good – downside, you have to get rid of remaining support structure at the area of the bow, where it it is glued with the other parts – sand paper will be your friend.
- I used 0.15mm and 0.2mm layer heigt. I personally prefer the 0.15.
- the design process was made with PLA Prusament Galaxy Black
How to built:
- print all parts, included the glued aid
- position the bottom ring with the rough side upside down into the glue aid – the smooth surface is now facing you
- spread glue onto the smooth surface of the upper ring (you can use a small needle to spread the glue onto the whole surface) and glue the upper ring onto the bottom ring using the glueaid – CAUTION: Do not use to much glue, because the glue is pressed outside.. this could cause your ring pair glued into the glue aid à unhappy glue experience
- spread glue onto the nose and the surrounding contact area of the bow and insert the nose of the bow into the curved hole of the glued ring pair
- spread glue to the contact areas of the bow a glue and press this onto the corresponding area of the handle
I would love to see printed copy of this, even “in action” photos would be highly appreciated. There is always room from improvment - please let me know if oyu have an idea. So take care and have fun out there!
Enjoy your copy of the “THE BLACK HORNET p2