1 / 5
Vertical Garden Tower parts for 100mm PVC DWV pipe. — image 1
1 / 5

Vertical Garden Tower parts for 100mm PVC DWV pipe.

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Parts for modifying a 100mm PVC pipe into a garden tower. Can be used in hydroponic, and aquaponic system setups.

Rating
0 / 5
Likes
97
Downloads
434
Makes
1
Views
4,463
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

I designed a garden tower that would side on top of my 100mm siphon shroud in an aquaponics system.

Complete 3d printed options would take too much filament and time and so I went with modifying a spare 65cm x 100mm (hole) PVC pipe instead. I used Silicone glue to secure and stop leakages on the pot holders only. It housed 15 lettuces.

Design features:

  • Easy quick prints
  • Easy assembly
    • Pot holders have lips as part of inserts, to assist when snapping them in. It also made gluing a lot easier.
  • Internal water dispensers fit garden hoses. (12mm inner diameter).
  • Requires a coupling to house and hold in the top dispenser place.
  • Dispenser was designed
    • in case of too much flow by funneling excess to the center.
    • allow dedicated air passage to flow up and down the pipe via the center.
  • Outer dispenser holes are pointed slightly outwards to encourage water to the pipe walls.
  • Drainage 100mm PVC pipes are cheap from the hardware stores (Bunnings in Australia has 6 meters for $45 AUD).

100mm PVC cuts and parts

  • Holes were made with a 64mm hole saw (I used a bi-metal).
  • Cut 3 per level, staggered evenly.
  • Each level of 3 was 10cm apart. Allowing a 20cm difference (measured from hole centers) between a hole directly perpendicularly up (every odd or even level pairing).
  • My working model has:
    • Use a coupling to fit and house the dispenser to top
    • Use a coupling to fit the tower to a 100mm siphon shroud at the bottom.
  • Other parts for my upgrade model will have:
    • Hanging from an M10 bolt and a U or S hook bolt.
    • Water fed in from closer to the top.

Print settings:

  • eSun PETG grey (more heat and UV resistant than PLA).
  • 3 walls
  • 0.2mm layer height
  • 0.4mm nozzle
  • 10% for dispensers, doesn't matter for the rest.
  • Supports
    • Required for the hose feed print. Also, need to place No Support areas within the tub.
    • Not required for all other parts
  • Cura Slicer Tolerence
    • Exclusive for the Dispensers and Top so they can screw together more smoothly
    • Middle (default) for the other prints.
  • Ender S1 Pro with Klipper firmware - Printed at 80-100mm/s - About 2hrs 45mins for a group of 3 pot holders. Managed to print everything needed for a 65cm pipe (5 levels) within 1 day.

Current Untested parts:

  • I have not tested the internal water dispenser (the intermittent ones).

Works in progress:

I am planning to build 1.5m - 1.8m towers.

  • A top screw in a dispenser that fits on top for hanging version of garden towers
  • A way to pipe in water from the top of the tower.
  • A method of pipe connection for exiting water into a pipe and/or tube.

Tags