Angular lampshade
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed to 3 different sizes
- Rating
- 5 / 5
- Likes
- 88
- Downloads
- 395
- Makes
- 2
- Views
- 1,823
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Wall-mounted
- License
- Creative Commons — Attribution
repost / remix of the original, which was relatively small
the version I've printed is 20cm at its widest, I've also made a 30cm version
These are more suitable for actually ceiling mounting on a pendant light in a decent size room
when the light shines through it you can see the thicker corners quite clearly which gives a nice effect.
the hole to mount the light pendant is 29mm, standard in the UK.
in the EU its 40mm I'm not sure about elsewhere but easy to modify for yourself.
print settings
Printed in ESUN PLA+
vase mode extrusion width 0.6 mm 0.1mm layers
minimum bottom layers needs to be about 2mm worth to give it a solid base.
edit- in retrospect i should have printed thinner or used a more translucent filament.
as my print reduced light output a little more than a lampshade should.
i printed with on masking tape smeared with superglue 70deg first layer
20 deg after that, this print took 21 hours so for these long prints i mount like this
as its very reliable but also uses up less electricity bed heating over all those hours