Handle for 24oz Thermos
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Handle for 24oz Thermos bottle.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 14
- Makes
- 0
- Views
- 159
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Thermos 24oz handle. Printed with ASA. Still figuring out what the best angle to print this at. I printed this with flat with organic supports and 6 walls at 15 infill. It is a little tight so I would widen it on PrusaSlicer about 1% or 2% and see if that loosens it up. I will try editing the file later but right now making the handle wider on the slicer is easier than doing it in Fusion 360. You will need a stainless steel 3mm rod approximately 42mm long. I bought some on Amazon for about $6.
Update. I was able to make the handle 1mm wider. I have not printed it yet to try it out. I will print it in PLA to test the fit and I will try another angle to print it as. The original works perfectly well but it is stiff. I would like to to be a bit looser.