Philips Sonicare charger holder with Schuko plug
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.78 – €0.96 net (excluding VAT)
For file: Fit test pieces.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.87 excluding VAT (range midpoint).
- Weight reported by the author
- 12 g
- Print time reported by the author
- 49.2 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A holder for Philips Sonicare charger with an integrated EU C Type -> Schuko plug adapter and cable storage compartment.
- Rating
- 4.862 / 5
- Likes
- 162
- Downloads
- 1,300
- Makes
- 33
- Views
- 5,370
- Reviews
- 29
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Upon seeing the OralB charger holder with Schuko plug, I wanted to make one for my Sonicare toothbrush.
I took inspiration from the OralB charger holders and took some “design advice” from the schuko adapter linked as remixes.
V1 was the initial version, V1.1 just adjusts so that the schuko plug sits on the print bed in the correct orientation when loading the file.
- The fit of the charger holder is quite tight, so use the charger fit check model, to ensure the charger has a little extra space to allow for pivoting the cable in, however be ready to make the cable suffer a little during insertion.
- The tolerances of the Schuko plug are quite snug, but after multiple retries, I just stuffed the cable in and called it a day - it fit tight, but it fit. Since it's a short print you can just try it out on your printer, shouldn't take more than half an hour.
- The Schuko backer plate fit test model is to check if the backing of the plug prints and fits with your printer. Print it and screw it on the schuko plug, to check if it fits well.
- You can use the Schuko backer plate models to extend the Schuko plug if you have some obstructions near the plug - I had to add 3 of the plates to allow it to clear the cap assembly my bathroom socket has.
- Additional hardware needed:
- 2x M3 nuts (pull them into the holes by pulling them in with a screw from the other side)
- 2x M3 screws (10mm if stock, longer if plug extended with plates)
Printed mine in white PLA @ 0.3mm layer height, infill at 20% and set to gyroid for a better surface finish. I did use supports, however set them only for areas with under 40 degree overhangs.
Onshape model available here.