1 / 10
Ultimate 5015 Hot End Fan Upgrade for Ender 3 S1 (Pro) + Sprite Extruder — image 1
1 / 10

Ultimate 5015 Hot End Fan Upgrade for Ender 3 S1 (Pro) + Sprite Extruder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Optimized air-flow to the hot end & significantly more silent! Lightweight.

Rating
4.867 / 5
Likes
246
Downloads
1,341
Makes
14
Views
11,012
Reviews
15

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — NoDerivatives

Check out also my Ultimate 5015 Part Cooling Dual Fan Duct for Ender 3 S1 (Pro) + Sprite Extruder

To silence the fan even more, print my Snap-On 5015 Blower Silencer

Design:

I have created this model with the following considerations:

  1. efficiently guide air to the back of the baseplate and into hotend
  2. ultra-lightweight
  3. much stiffer probe mount
  4. better clearance to extruder lever
  5. snap-on mount for the 5015 blower
  6. reuse original screws only

Printing instructions:

  • you need to print BOTH MODELS backplate + 5015 mount
  • printing orientation on bed as shown in picture
  • material: use PETG or better (avoid PLA, due to low heat resistance)
  • layer height: 0.2mm or smaller
  • use 5 perimeters
  • supports on build plate only
  • infill: any

Fitting instructions:

  1. disassemble the extruder and replace the backplate using original screws
  2. use 24 Volt 5015 blower and splice/solder/crimp onto a stock connector
  3. file down small amount of plastic on the bottom part of the blower → this will ensure a tight fit in part
  4. snap-on the blower and rotate it in it's final position
  5. secure the fan with a glue gun
  6. don't forget to do a PID calibration for your extruder !!!

_________

Version history:

v1.0

13.3.2023

  • initial release

Tags