1 / 10
Ultimate 5015 Hot End Fan Upgrade for Ender 3 S1 (Pro) + Sprite Extruder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Optimized air-flow to the hot end & significantly more silent! Lightweight.
- Ocena
- 4,867 / 5
- Polubienia
- 244
- Pobrania
- 1336
- Wydruki
- 14
- Wyświetlenia
- 10 941
- Oceny
- 15
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 14) (Komentarze: 25)Remiksy (0)Kolekcje (343)Powiązane
Check out also my Ultimate 5015 Part Cooling Dual Fan Duct for Ender 3 S1 (Pro) + Sprite Extruder
To silence the fan even more, print my Snap-On 5015 Blower Silencer
Design:
I have created this model with the following considerations:
- efficiently guide air to the back of the baseplate and into hotend
- ultra-lightweight
- much stiffer probe mount
- better clearance to extruder lever
- snap-on mount for the 5015 blower
- reuse original screws only
Printing instructions:
- you need to print BOTH MODELS backplate + 5015 mount
- printing orientation on bed as shown in picture
- material: use PETG or better (avoid PLA, due to low heat resistance)
- layer height: 0.2mm or smaller
- use 5 perimeters
- supports on build plate only
- infill: any
Fitting instructions:
- disassemble the extruder and replace the backplate using original screws
- use 24 Volt 5015 blower and splice/solder/crimp onto a stock connector
- file down small amount of plastic on the bottom part of the blower → this will ensure a tight fit in part
- snap-on the blower and rotate it in it's final position
- secure the fan with a glue gun
- don't forget to do a PID calibration for your extruder !!!
_________
Version history:
v1.0
13.3.2023
- initial release