Raspberry PI 4 Mounting Wall Gizmo - ElementSystem Compatible
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.18 – €1.45 net (excluding VAT)
For file: raspberry-pi-4-mounting-gizmo-back-plate-v16_01.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.32 excluding VAT (range midpoint).
- Weight reported by the author
- 12 g
- Print time reported by the author
- 1.53 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Raspberry PI 4 mounting wall gizmo was designed to be compatible with the tool wall plate produced by Element System.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 30
- Makes
- 0
- Views
- 715
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
Raspberry PI 4 mounting wall gizmo was designed to be compatible with the tool wall plate produced by Element System.
The tool wall plate:
https://element-system.com/en/tool-storages/storage-sets.html
Gizmo is divided into 2 parts so they can be easily printed.
1) Pillars - 4 pillars between the back-plate and the RPi
2) Back-Plate - mounting gizmo including the wall hooks.
Hooks on the back-plate shall be placed upwards during the printing. They are printed without any support easily.
There is also a similar gizmo for a SSD if you need it.
https://www.prusaprinters.org/prints/41550-ssd-7mm-mounting-wall-gizmo-elementsystem-compatib
Print instructions
Rafts: No
Supports: No
Resolution: 0.15 mm
Infill: 15%
Filament: Filament PM PLA Pearl Red