LNA4ALL Low Noise Amplifier Cover Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Custom-made enclosure for a LNA4ALL Low Noise Antenna Amplifier (http://lna4all.blogspot.com).
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 73
- Makes
- 0
- Views
- 717
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Custom-made enclosure for a LNA4ALL Low Noise Antenna Amplifier (http://lna4all.blogspot.com). Note this is NOT a radioelectric proof case, it is just a mechanical protective box to preserve the electronics.
It is made in two pieces: base and lid. The lid has the words "in" and "out" printed to distinguish the amplifier terminals once closed. "G" letter is my signature (if you don´t mind...)
Designed to use any M2.5x10 flathead screw. Two side tabs with 3 mm. holes allows to fix it on any surface,
Be carefull when inserting the electronic part, inside fitting is extremely tight (exact). Don't force the circuit board, you will probably need to slightly trim four tiny bulges on the circuit board rim.
Print instructions
Category: Electronics Summary
Custom-made enclosure for a LNA4ALL Low Noise Antenna Amplifier (http://lna4all.blogspot.com). Note this is NOT a radioelectric proof case, it is just a mechanical protective box to preserve the electronics.
It is made in two pieces: base and lid. The lid has the words "in" and "out" printed to distinguish the amplifier terminals once closed. "G" letter is my signature (if you don´t mind...)
Designed to use any M2.5x10 flathead screw. Two side tabs with 3 mm. holes allows to fix it on any surface,
Be carefull when inserting the electronic part, inside fitting is extremely tight (exact). Don't force the circuit board, you will probably need to slightly trim four tiny bulges on the circuit board rim.
Print Settings
Printer Brand: Prusa
Printer: Prusa Mk2
Rafts: No
Supports: No
Resolution: 0.150 mm.
Infill: 20%