Coke Water Reservoir
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Water Reservoir for American Flyer (and like size) Train scenery
- Rating
- 0 / 5
- Likes
- 17
- Downloads
- 40
- Makes
- 0
- Views
- 451
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
Replaced the printed tank part with a coke or like sized can. Sp[ray painted it white. Cut out and peeled the logo from a couple of Coke Zero 16 oz bottles, and attached to can with stick glue.
The top is sized to snap onto a coke can. The hole for the pipe may need to be reamed with a drill bit. I did not remove the brim (It printed great standing upright. I deleted the center part of the original pipe.) Inserted the pipe so the brim fit down on the bottom printed part and held it in place. The pipe is 12mm longer that the original to reach to the base.
The legs are very precise fit. I actually reamed them also then glued.
The legs are angled inward. They are set correctly on the plate to print right. Need to print two (2) sets of two (2) for the four (4) sides. Recommend using a fast setting glue like Rapid Fuse.