Height adjustable stand for tablets and phones
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adjustable in height between approximately 50-170mm Fits devices up to a width of 9mm
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 39
- Makes
- 0
- Views
- 650
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
To raise the stand simply pull the gantry up, to lower it you pinch the knobs at the back that are green and yellow in the picture.
I color coded all parts so you easily can see how to put it together.
There are two foots, one with a 7.5 degree angle and one with a 5 degree angle, files are named accordingly.
There is three front parts for a device with a maximum thickness of 6.5mm, 7.5mm and 9mm. Files are named accordingly.
You will need support for the Front part and for a small part of the Back part (see screenshot), all other parts prints without support and loads in the correct printing orientation.
I printed with 0.2 layer and 4 perimeters. Infill doesn’t matter much.
PLA is stiffer than PETG and my preferred filament for this one but it works well with other non-flexible filaments as well.
-You have to keep the moving joints movable:
Don’t tighten the screws in the green knob and the blue distance to tight, make sure you can twist them without them being too loose, this also applies to the screws that goes into the back part.
Hardware needed:
13 M3x10 cap head screws