Cisco 7970 replacement stand mechanism
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€2.80 – €3.43 net (excluding VAT)
For file: cisco7970.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.12 excluding VAT (range midpoint).
- Weight reported by the author
- 19 g
- Print time reported by the author
- 3.73 hr
- Source material
- ABS
- Estimate material
- ABS
- Estimate printer
- Bambu Lab X1 Carbon - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a replacement "clip" for the inside of a Cisco 7970 (and any model with the same case).
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 28
- Makes
- 0
- Views
- 262
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution
This is a replacement "clip" for the inside of a Cisco 7970 (and any model with the same case).
As you can see in the image the original clip disintegrated so I decided to model is in Fusion 360 and print it.
There are two versions. The SIMPLE one is easier to print as it doesn't have all the extras but works perfectly fine.
I strongly recommend you print this in PETG as PLA is probably going to snap quite quickly.
Print instructions
Category: DIY Summary
This is a replacement "clip" for the inside of a Cisco 7970 (and any model with the same case).
As you can see in the image the original clip disintegrated so I decided to model is in Fusion 360 and print it.
There are two versions. The SIMPLE one is easier to print as it doesn't have all the extras but works perfectly fine.
I strongly recommend you print this in PETG as PLA is probably going to snap quite quickly.
Print Settings
Printer: Anycubic Kossel
Rafts: No
Supports: Yes
Resolution: 0.1
Infill: 30
Notes:
In order for the fine parts to work this needs to printed at 0.1 or better. Also make sure your supports come off clean.