Drybox Outlet for PTFE Tube (Festo fitting QSM-M5)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
To prevent the filament from absorbing moisture and degrading, such as ABS, ASA or water-soluble filaments, it should…
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 42
- Makes
- 0
- Views
- 1,024
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
To prevent the filament from absorbing moisture and degrading, such as ABS, ASA or water-soluble filaments, it should always be kept dry
To ensure that the filament remains dry during printing, it is recommended to print directly from the Drybox.
For this purpose I have an adaptive outlet which can be closed again after printing by inserting a lid.
The design is made for the Festo QSM-M5 fittings. These can be easily tightened with an open-end wrench. Due to the countersink it seals well.
For the attachment to the drybox I recommend to use more glue instead of screws, because the glue also acts as a seal.
Do not glue your fingers when sticking the glue ;D and roughen the glue surface to increase the adhesion.
You are welcome to remix and split the model. I am interested in your opinion, because only through feedback you can become better :P
Happy Printing :D
Print instructions
For the outlet system you need a Festo QSM-M5 fitting, fitting adapte, lid and a holder.
The layer height for an optimal result is 0,15mm.
PRUSAMENT PETG JetBlack was printed with a nozzle temperature of 240/250°C and a bed temperature of 85/90°C.
Extrusionfactor 0.95 (variable)
100% Infill