ARB fridge display protection / blanking door
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
ARB fridge display protection / blanking door
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 21
- Makes
- 0
- Views
- 329
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Public Domain
This is a cover for a 50L ARB Fridge Freezer display.
It may fit other ARB fridge display however I have not tried .
When I go camping and the ARB is sitting outside at night, the display gives off a lot of light and can attract the attention of undesirable. Or when inside the RV I like the total darkness .
I also use the ARB on my motorcycle tent trailer this permit it to look like a inexpensive cooler.
This is a simple door that hides the display and blocks the display illumination and is easily flipped up to view the display.
It was printed in PLA with an infill of 25%
The inges were affixed to the fridge via 2 way tape.
Extra Idea,
If you wish to partially see the power LED you could either drill a small hole on the cover.
Or in Pruslicer you could add a couple of negative cylinder just enough to block the top and bottom layers allowing the internal infill to remain and partially blocking the LED view at certain angles.