1 / 3
Balisong case and insert for 4 Arasaka knifes
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Isert for Arasaka balisong butterfly knifes, see remix. Fits 4 knifes.
- Rating
- 0 / 5
- Likes
- 37
- Downloads
- 143
- Makes
- 0
- Views
- 2,136
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Insert works with both Arasaka Balisong Butterfly Knife versions, this insert is for V2 specifically.
To print Arasaka logo into the case on a same bottom layer, its possible to do with single extruder.
See my guide how to here: MMU Printing for Any Printer: Creating the Stone Award
Note that this guide only works with PrusaSlicer
Print settings
- Insert - anything works
- Case lid with logo - you need to setup two virtual extruders before opening the .3mf file, check how with link to guide above
- 0.2mm layer height, or change the logo height to match two layers eg. 0.3mm = logo 0.6mm high, scale without constraints
- Bottom fill pattern, I used concentric
- No supports needed
- Case lid and case bottom (no logo) - no supports needed, 0.2mm layer height suggested.
Hardware needed
- 6 M3x30mm screws, or just 2 if you don't add latches.
Balisong insert works with M4 and M3 screws and of course with printed pins. Knifes should fit snugly and doesn't drop out if held upside down.