Prusament Cardboard Box Hex Plug
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.11 – €0.14 net (excluding VAT)
For file: Hex_Plug_Wedge_Final_Concentric_200C_0.2mm_PLA_MK3S_9m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.12 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 9 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Plug to close the hole in Prusament boxes. Now these boxes are good to reuse for stuff.
- Rating
- 5 / 5
- Likes
- 5
- Downloads
- 34
- Makes
- 1
- Views
- 277
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I know a good cardboard box when I see one. It must be my ocd side…. I can't thow them away! Prusament boxes are very nice, strong and of a nice size. Their only drawback is that there is a big hole right in the middle of it!
So I made these plugs and now I can store things in them without fear of bits falling out!
Tools, prints, parts, electronics, toys, xmas decorations…. freedom of choice :)
The the hole must be made out of a die cutter so every boxes should be identical. I made the plugs fit very tight and precise. It just fit on any Prusament boxes! There are 2 versions. One is a wedge that snaps in place but leaves an uneven surface inside. The other is made of 2 flat parts that ‘press’ together leaving a smooth wall inside. I made one ‘female’ part with dimples around the edge so the hex parts fit more tightly. I suggest snaping the outside THEN gently press on the center to avoid damaging your parts.
I provided 2 gcodes files with bottom layer with concentric pattern to make it look better!