Simple Housing for Nextion 3.5" Display
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simply case to wall mount a Nextion NX4832T035 LCD display
- Rating
- 5 / 5
- Likes
- 11
- Downloads
- 179
- Makes
- 2
- Views
- 1,343
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
I needed a simple case to house the Nextion LCD that's attached to a JKTech enclosure controller where the controller board wasn't attached to the back of it.
The base screws to a flat surface, in my case the wall, and the screws holding the front to the base also securely mounts the display. The base is designed with 4mm holes to take standard m3 brass inserts. I've used some m3 x 10mm knurled bolts as I had them kicking about but suitable cap/button/cheesehead bolts will work. The front is not countersunk.
I probably don't need to say, but it prints without supports. My use case works fine with PLA.