1 / 4
Arduino UNO / Duemilanove / Diecimila / Leonardo / NG / Extreme Drilling And Mounting Plates — image 1
1 / 4

Arduino UNO / Duemilanove / Diecimila / Leonardo / NG / Extreme Drilling And Mounting Plates

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This thing is obsolete. It is replaced by https://www.thingiverse.com/thing:2599820.

Rating
1 / 5
Likes
4
Downloads
99
Makes
1
Views
633
Reviews
1

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial

This thing is obsolete. It is replaced by https://www.prusaprinters.org/prints/43002-classic-arduino-mouning-plate .

This thing contains a mounting plate and a drilling guide for the “Arduino UNO / Duemilanove / Diecimila / Leonardo / NG / Extreme”.

The plates are not symmetrical. The notch shall be on the power jack and Ethernet cable side. The baseplate is 2 mm thick. M2 5 mm or 1/4″ 4-40 screws are needed to fasten the board to the mounting plate. The mounting holes are three mm in diameter.

The holes do not go through the lower layer to make it easier to print. You will have to drill them.

Tags