Ikea Moppe Drawer Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Had some drawers leftover from the IKEA Moppe bookcase project for our sons room. Decided to re-use them.
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 37
- Makes
- 0
- Views
- 535
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
Had some drawers leftover from the IKEA Moppe bookcase project for our sons room, based on this IKEA hack. Decided to re-use them. In my small workshop i have a shelf where I can mount them underneath, therefore I needed a holder. The hole fits a 3,5 mm countersunk woodscrew.
Designed in Tinkercad, I tried to make a design which is fast printable without support and also material efficient.
Print settings:
Resolution: 0.2 mm
Nozzle 0.4 mm
Supports: depending on orientation (see below)
Material: PLA+
Additional instructions:
The both side panels were printed flat, the center part is printed upright (see below). For the center part a large brim was used because of poor adhesion resulting in a failed print.
