Ikea Moppe Drawer Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Had some drawers leftover from the IKEA Moppe bookcase project for our sons room. Decided to re-use them.
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 535
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Had some drawers leftover from the IKEA Moppe bookcase project for our sons room, based on this IKEA hack. Decided to re-use them. In my small workshop i have a shelf where I can mount them underneath, therefore I needed a holder. The hole fits a 3,5 mm countersunk woodscrew.
Designed in Tinkercad, I tried to make a design which is fast printable without support and also material efficient.
Print settings:
Resolution: 0.2 mm
Nozzle 0.4 mm
Supports: depending on orientation (see below)
Material: PLA+
Additional instructions:
The both side panels were printed flat, the center part is printed upright (see below). For the center part a large brim was used because of poor adhesion resulting in a failed print.
