Jar Resin Wash Station

I make a little washstation for a Jar (diameter 94 mm)

you need:

1 x Bearing (608 ZZ, optional)

9 x Magnets (10 x 3 mm)

2 x Magnets (6 x 3 mm)

1 x electric motor with around 1750 rpm e.g. Amazon Link.

1 x Switch e.g. Amazon Link

2 x battery connection e.g. Amazon Link

1 x battery connection e.g. Amazon Link

printing settings:

Gitter-Part1.stl, Washstation-getr_unten.stl and Washstation-Krob_unten.stl need supports

I print Washstation-Zahnrad_1.stl, Washstation-Zahnrad_2.stl, and Washstation-Zahnrad_1.stl on a raft.

Introduction:

You don't need glue.

The magnets on the middle of Gitter-Part1.stl, Washstation-Antrieb.stl and propeller-prop_unten.stl must have the same pol. The Magnets on outside of Washstation-Antrieb.stl and propeller-prop_oben.stl must have another pol as the middle magnet.

The parts propeller-prop_unten.stl and propeller-prop_unten.stl has a connetion with the bearing.

The distance between the magnets and the jar is very importent. Is the distance to high the rotor not turn. if it to low the maschine don't work good. I constructed a distance of 0,5 mm but the tollerance of my printer was to big, so i make Abstand.stl. I needed Abstand.stl in z = 3mm. If you have the same problems, you must find the right z in Abstand.stl.

Update 14.01.2022:

Washstation-Zahnrad_2_v1.stl is now higher for a better magnetic connection.

Update 18.01.2022:

I used a steel bearing. This wasn't my best idee and i construct a bearing in propeller-prop_unten.stl. If you want use the bearingless version print Probeller_unten_ohne_608.stl without supports.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

Yes

Supports:

Resolution:

0,2

Infill:

Filament: Sunlu, ESun PLA Wood (Sunlu), PETG (ESun), PLA+ (ESun) wood, black, transparent

Notes:

Category: 3D Printing