Tapo C100 crib magnet mount + STEP & F3D
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Crib side magnet mount for Tapo C100 camera + STEP & F3D (Fusion 360) files.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 116
- Makes
- 0
- Views
- 704
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
You'll also need
8x3mm Magnet x2
CA/Super/Instant glue for plastic parts
Epoxy or other glue for magnets
Instructions
- Print camera plat and glue helper part flat, print the clip on its side
- Use more perimeters for the clip, e.g. 4
- Use flexible infill for the clip, e.g. “Rect” or no infill at all.
- Use the glue helper part to align the clip and the camera plate. I attached the helper to the plate with a masking tape for example and removed after the clip is glue to the plate. Even if you manage to glue to helper to the plate too it'll not look terrible.
Notes
The camera has thin rubber pads on the bottom, so ideally you want the magnets to stick out 1-1.5mm so that the touch the metal screws on the bottom of the camera. In my first print there was a 1mm gap and it still works fine, but if they touched it'd be even better. The uploaded design has holes for magnets less deep, so that 8x3 magnets stick out a bit.
Gratitude
Please leave a Like 🤍 if you liked it :)