1 / 2
Hose clamp for thin hoses
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hose clamp for silicone hose (8mm ID x 11mm OD) using a M3 screw and a M3 thread insert.
- Rating
- 5 / 5
- Likes
- 27
- Downloads
- 71
- Makes
- 1
- Views
- 529
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Because the silicone hose I bought for the air assist was a little too loose on the compressor, I developed a small hose clamp.
Print the clamp with supports in the orientation shown. Then melt in the threaded insert with the soldering iron. I used PETG for the print - works very well. You also need a M3 screw with a lenght of approx. 12mm and a washer.