Halo Nerf Needler Display Stand Corner Retainers
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Corner retainers for the Halo Nerf Needler display stand. Finally, the Nerf Needler display is virtually cat-proof.
- Rating
- 0 / 5
- Likes
- 28
- Downloads
- 30
- Makes
- 0
- Views
- 1,570
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to wall mount my Needler, but I have cats and I didn't want them to knock the stand off and destroy my Needler when they aren't supervised, so I designed these corner retainers to sit the display base on. Now my Needler sits on the wall undisturbed and I don't have to worry about it sliding around and falling.
All printed components were PLA made at 0.2mm resolution with 20% infill, however, if you use the same shelf brackets for anything heavier than this particular project, I recommend printing them at 30-40% infill. The shelf brackets should also be printed horizontally with a brim, as mine kept detaching from the bed.
Required components:
- Corner retainers (x4)
- M3 12mm screws (x8)
- M3 7mm washers (x4)
Optional extra components for making a dedicated Needler shelf:
- ¾ inch thick wood, cut to 15 ¾” by 7“ (I sanded mine and painted it pink. Don’t forget to sand the corners so it doesn’t have sharp edges!)
- Archi Shelf Brackets by GO_Strawbs on Thingiverse
- M4 14mm screws (x4)
- M4 30mm screws (x4)
- M4 8mm washers (x8)
- Wall anchors (x4)
Keep in mind that the shelf brackets must be affixed to the wall before attaching the wooden shelf. Pre-drilling the shelf holes will also make installation 4x safer and easier. There are 16 holes in total to pre-drill: 8 on top for the corner retainers, 4 on the bottom for the shelf brackets, and 4 in the wall that are big enough to put anchors into.