QuinLed Dig-Uno Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
case for a QuinLed DigUno. includes space to allow wire ferrules.
- Rating
- 5 / 5
- Likes
- 25
- Downloads
- 237
- Makes
- 3
- Views
- 1,350
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Case for Quinled's DigUno WLED controller.
uses pins to mount/hold the board in the case, no tooling required. You can melt down the pegs with a soldering iron to further secure, but it's not really going anywhere.
Space for the wires to use wire ferrules. then bend the wire through the track. If you need to further secure the wires, a blob of hot glue in the track should provide adequate pull resistance.
Lid is held in place with two tabs/detents. snap lid on and it's quite secure. open by pulling with a moderate amount of force.
can be printed without supports. images shown are PLA in orange, and ASA in white.
my first upload. hope it works for others too!