1 / 4
Printed MakerBeamXL 1515 Extrusions for Voron 0.2 Tophat — image 1
1 / 4

Printed MakerBeamXL 1515 Extrusions for Voron 0.2 Tophat

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Got a Voron 0.1 and you want to upgrade to the 0.2 tophat but you can't source the extrusions? Well just print them!

Rating
5 / 5
Likes
112
Downloads
588
Makes
4
Views
3,601
Reviews
3

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

Printed MakerBeamXL 1515 extrusion and Clips to join them together.

"Why not use TinnT's or ryandam's solutions? They seem much sturdier and easier to print than this"

Because I plan to use future 0.2 tophat mods, such as chirpy's Tophat Cat Flap mod that adds a hinge door for the tophat, which was designed around 1515 extrusions. Also they become sufficiently strong after adding the panels anyway (I still wouldn't drop them though).

Print Settings

  • Extrusions:
    • Layer height: 0.3 mm (you could set it lower, it'll just take forever to print)
    • Top/bottom layers: 0
    • Infill: 0%
    • Wall count: 1
    • Wall width: 0.8 mm
    • Speed: 40mm/s or slower (the slower the better)
    • Arachne required
    • 0.6 nozzle recommended
  • Clips:
    • Normal Voron settings

Print some samples to test the fit and tolerance, adjust the tolerances on the SCAD file. You could adjust the slot_tolerance so the m3 hex nut fits snuggly in the extrusion, no no-drop-nuts required.

Assembly

If you do not have 200mm of z height (such as on a Voron 0), split the extrusion into 2x100mm and use the Extrusion Clips to join them together. Join them on 2 sides of the extrusion (the ones facing inside).

Then assemble them following the normal Voron 0.2 tophat instructions, tap and drill them for the blind joints as you would on an aluminium extrusion.

Tags