Breadboard Wire Storage Box
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A 10" hinged box. I designed it specifically for storing breadboard wires.
- Rating
- 5 / 5
- Likes
- 31
- Downloads
- 117
- Makes
- 1
- Views
- 1,064
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Tired of spaghetti wires everywhere during a breadboard project? Here's a nice hinged box to store them in. It's 10" so for normal Ender 3's will most likely have to print on a 45 degree angle to fit it within the build volume.
Requires 2 2mm x 100mm metal rods for the hinges and small magnets heat inserted to ensure the lid stays closed.
The lid opens at 135 degrees (45 degree open angle). Has end stops to avoid joint damage while open.
Estimated print time is about 35 hours each for the top & bottom case at 50mms.
.3mm spacing built into the model between components. All you should have to do is print it. :)