Prusa Filament Guide 4mm PTFE adaptor Insert
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An insert for the new Prusa Filament Guide compatible with common 4mm OD PTFE tubes.
- Rating
- 5 / 5
- Likes
- 53
- Downloads
- 392
- Makes
- 30
- Views
- 1,341
- Reviews
- 23
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
I created this insert because I have a ton of 4mm OD PTFE tubing and I'd like to use the new filament guide on my other printers.
-No additional Hardware Needed.
-Printing in .2 Layer Height works best, material type shouldn't matter too much.
-Make sure you print it in the same orientation that the model loads in as since there is a very small lip that keeps the PTFE tube from passing thru on one side.
-Cut two 7mm lengths of 4mm OD PTFE tubing to insert into the adaptors.
-Follow the Prusa Instructions to assemble the Filament guide: https://help.prusa3d.com/guide/filament-guide-addon-mk4_413227