Simple phone stand for Octo4a
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple phone stand to use an (old) android phone for Octoprint using Octo4a. Only needs 2x M4x16 screws.
- Rating
- 5 / 5
- Likes
- 20
- Downloads
- 141
- Makes
- 5
- Views
- 826
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
Simple phone stand to use an (old) android phone for Octoprint using Octo4a. Only needs 2x M4x16 screws to attach the holder to the base. This lifts the bottom edge of the phone about 80mm of the table, and with the screws you can tilt it up and down. I feel this gives a fairly good view on the bed of my Tevo Tarantula based monster.
I printed them in generic PLA with 0,2mm layers, 3 outlines and 10% gyriod infill. The phoneholder “OctoPhone” was printed flat on it's back and the stand “OctoPhoneBase” upright. No supports needed.