1 / 2
Pickleball Net Repair Part
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a solution for when the center pole of a pickleball net breaks through the top of the net
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 90
- Makes
- 0
- Views
- 612
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Indoor Sports
- License
- Creative Commons — Public Domain
This is a sturdy repair for when the center pole of a pickleball net breaks through the top ‘tape’ of the net.
I recommend:
- Use TPU type filament for strength and durability
- Print the part laying on its side for maximum strength in the critical axis
No need for supports but one side of the 'channel' exterior could look a little rough - 0.2mm layer height works fine
INSTALLATION: You need two smaller Zip Ties. Poke four holes in the net's top tape to match the holes in the repair part. Insert the Zip Ties as shown in the photo, pull tight and snip off the excess (try not to leave any extra ‘stub’ projecting in the Zip Tie to avoid someone being scratched by a sharp edge.)