Filament dryer extension for Gorenje dehydrator
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Extension piece (1/4) for Gorenje FDK500GCW food dehydrator with lid diameter ~31 cm.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 41
- Makes
- 0
- Views
- 450
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
Bottom external diameter – 300 mm, top external diameter – 306 mm.
You need 4 parts to create a cylinder. Print 2 test pieces to check if they fit nicely with your print settings. If the piece slides too hard – you can drill the hole part out with a 4 mm drill.
The model is printed upside down with no supports. Make sure to create enough brim on the base (I used 5mm) as the model is quite thin.
I would recommend choosing PETg over PLA as more suitable for high temperatures.
You can set your own diameters using Fusion 360 file attached – edit parameters and export part named “tweaked”. I slightly edited the file to automate 1 parameter – the model was created by the original author @Haprog.
P.S.
Also, check this remix of the original extension for the same Gorenje model.
P.P.S.
It was found that a 20-liter plastic bucket from the mall fits this dehydrator perfectly, so check maybe you don't need to print the extender. ;)