Robot Arm V1
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is my first go at developing my own robotic arm.
- Rating
- 3 / 5
- Likes
- 395
- Downloads
- 1,096
- Makes
- 0
- Views
- 21,546
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Engineering
- License
- Creative Commons — Attribution — Noncommercial
This is my first go at developing my own robotic arm. It uses an Arduino UNO, 16 Channel Servo Motor Shield, and 2 Joysticks (all sourced from Adafruit). This version was developed around the SG90 servo, which unfortunately was much too weak. It ended up collapsing under its own weight. I suspected this but wanted to develop under that constraint, building a foundation for future designs. All parts are 3D printed.
Everything except the screws were Printed at 0.2mm, 15% infill, 4 perimeters. The screws were printed at 0.07 layer height, 100% infill.
Even though this model isn't fully functional, I still thought it was worthwhile to share with the community.
More robust versions will follow in the future, each with increased capabilities.
Print instructions
Most Parts:
0.2 mm
15% infill
4 perimeters
215 degrees C
Screws:
0.07mm
100% infill
215 degrees C