Ram Mount vibration isolator / damper
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
RAM GPS mount
- Rating
- 0 / 5
- Likes
- 21
- Downloads
- 57
- Makes
- 0
- Views
- 1,248
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I made this primarily for my RAM GPS mount; When attached to my motorcycle, the vibration would always cause my Garmin GPS to shut off after a few minutes of riding.
With this installed, my GPS stays on during my rides (both on & off-road).
The last picture shows the actual rubber dampers I used, along with the dimensions. many hobby stores sell these dampers.
Made to fit standard Ram 2-hole (AMPS) mounts, between device holder / cradle and Ram mounting ball.
Make sure you have a backup lanyard / tether tied to your device and motorcycle; This also acts as a break-away in case of a fall.
Instructions
Print with the hex nut holes DOWN, with supports.
I prefer to print PLA with 5 top & bottom layers, 2 vertical "walls", 0.2 mm height, 25% - 40% infill.
Print two parts for 1 Vibration Damper.
Has provisions for 5 rubber dampers, minimum of 4 are required.
If you like my designs and want to send me a tip, you can do so via PayPal….. Thank you and enjoy the models I create.