Adapter for Prusa spool holder, for the Original Prusa Enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount the original spool holder of your MK3S onto the Enclosure. Existing holes are used, no drilling is required
- Rating
- 4.909 / 5
- Likes
- 80
- Downloads
- 329
- Makes
- 11
- Views
- 1,654
- Reviews
- 11
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is part three of my enhancements/addons for the Original Prusa Enclosure (see my other models here on Printables).
In addition to the two spool holders inside the Enclosure, I wanted a spool holder on top of the case. So I designed a mount for the original spool holder of my MK3S+. It is an assembly of a holding block, a spacer plate and a adapter plate for the Prusa spool holder, assembled with four M3x20 countersunk screws plus nuts. The holding block itself is attached to a base plate using four M3x10 Allen screws and M3 nuts. And this base plate is fastened to the top plate of the Enclosure using four given holes and likewise four M3 nuts and Allen screws, two of length 8mm and two of 12mm. The latter of 12mm also hold an item with three PC4-M10 pneumatic connector fittings, through which PTFE tubes are led to the inside of the Enclosure.
I printed everything with PETG. For the adapter plate and the spacer plate I used an infill of 60%. Every other part got an infill of 40%.