1 / 3
Magnetic Organizer
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Trays and boxes in different sizes that snap together with magnets
- Rating
- 5 / 5
- Likes
- 89
- Downloads
- 106
- Makes
- 1
- Views
- 1,464
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Mix and match your own combinations of trays and boxes of different sizes.
Parts of one organiser:
- shell (vase mode)
- insert (vase mode)
- opaque layer
- magnet holder
- 5mm (or smaller) neodym sphere magnets (square: 8 magnets; rectangular: 12 magnets) - Need another size? Just ask!
Print instructions:
- layer height: 0.2-0.3mm
- shell
- vase mode
- wall thickness (external perimeter/outer wall): 0.8mm
- bottom layers: 2-3 (0.6mm thickness)
- insert:
- vase mode
- wall thickness (external perimeter/outer wall): 0.8mm
- bottom layers: 2-3 (0.6mm thickness)
- magnet holder:
- print normally
- opaque layer (makes sure the magnet holder doesn't shine through the bottom):
- print normally
- you can glue all parts together (not absolutely necessary if it fits together tightly) but don't glue the magnets themselves!
If you're unsure about whether the insert will fit properly: Print the test files in vase mode with an external perimeter/outer wall of 0.8mm. Check the tightness of the insert. If it's too tight, reduce perimeter/wall size of the shell until it fits your needs..
See the organiser in action here: