Moonlander + Platform case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A hard shell case for the ZSA Moonlander keyboard with the platform attachment. Has pegs that fit in the platform holes.
- Rating
- 5 / 5
- Likes
- 22
- Downloads
- 119
- Makes
- 1
- Views
- 3,352
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Share Alike
A hard shell case for the ZSA Moonlander keyboard with the platform attachment. Has pegs that fit in the platform holes. The cable connecting the two halves can also fit with some work. The thinnest piece is the bottom, the lids come down over it.
The top and bottom lids can be printed flat side down without support. The middle section is trickier. I printed it peg side down with supports. The supports came off easily with some pliers but the finish is not the best (last picture). Printed with 3 perimeters and 50% infill on an Ender 3 V2 neo and creality PLA. The top and middle sections took about a day each, the bottom about 12 hours.
The latches are "Rannb Toggle Latch Mini Size" from amazon and super glued on. I also expiremented with paulorfo's lever latch scaled to about 60%, which looked like it would also work nicely.
The OpenSCAD model is mostly parametric if you want to adjust thickness, tolerances, or adapt to a moonlander without the platform.
Note: The rims as-is have some wiggle room, but the friction from where the latches overhang gives a nice firm fit. Adjust “rim_tolerance” in the model file as needed.