Bass Clef Headphone Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Created to hold my computer headset and as a double bass player wanted something unique to me. Ends up about 20cm / 8…
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 62
- Makes
- 0
- Views
- 454
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
Created to hold my computer headset and as a double bass player wanted something unique to me. Ends up about 20cm / 8 Inches tall and Clef is 25mm / ~1 inch wide
Prints as 2 pieces for no support printing, that can then slide together easily. Makes for easy assembly/disassembly and flat transport if required.
You could of course glue it together should you want it permanent and/or tighten the tolerances on the hole if you just want a tighter fit (I left it fairly loose so wouldn't have to re-print if it was too tight)
Remixed from Bass clef: https://www.thingiverse.com/thing:93518
and Makerbot stand: https://www.thingiverse.com/thing:2050885
Printing:
I did at 0.3 and 10% cubic as that was good enough for this piece IMHO and wanted it faster. But could do at less if you prefer a finer finish.
Print Settings
Printer:
Voxelab Aquila
Rafts:
No
Supports:
No
Resolution:
0.3
Infill:
10
Filament:
Flashforge PLA+Black
Notes:
Each piece fits on Voxelab Aquila 220x220 bed or similar Ender 3 clone.
If you want it taller you probably can upscale still a bit more and fit.I printed flat with no supports and .3 to save time using 3dprintSOS's Aquila profile @ 10% with cubic subdivision pattern.
Clef took ~5h Base ~3h at my settings
Category: Organization