Bass Clef Headphone Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Created to hold my computer headset and as a double bass player wanted something unique to me. Ends up about 20cm / 8…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 62
- Wydruki
- 0
- Wyświetlenia
- 454
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
Created to hold my computer headset and as a double bass player wanted something unique to me. Ends up about 20cm / 8 Inches tall and Clef is 25mm / ~1 inch wide
Prints as 2 pieces for no support printing, that can then slide together easily. Makes for easy assembly/disassembly and flat transport if required.
You could of course glue it together should you want it permanent and/or tighten the tolerances on the hole if you just want a tighter fit (I left it fairly loose so wouldn't have to re-print if it was too tight)
Remixed from Bass clef: https://www.thingiverse.com/thing:93518
and Makerbot stand: https://www.thingiverse.com/thing:2050885
Printing:
I did at 0.3 and 10% cubic as that was good enough for this piece IMHO and wanted it faster. But could do at less if you prefer a finer finish.
Print Settings
Printer:
Voxelab Aquila
Rafts:
No
Supports:
No
Resolution:
0.3
Infill:
10
Filament:
Flashforge PLA+Black
Notes:
Each piece fits on Voxelab Aquila 220x220 bed or similar Ender 3 clone.
If you want it taller you probably can upscale still a bit more and fit.I printed flat with no supports and .3 to save time using 3dprintSOS's Aquila profile @ 10% with cubic subdivision pattern.
Clef took ~5h Base ~3h at my settings
Category: Organization