All in One Temperature & Bridging Tower - PLA & PETG GCode included
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€2.34 – €2.86 net (excluding VAT)
For file: MK4 PLA Temp Tower / temp-tower-190-230_04n_02mm_pla_mk4_2h55m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.60 excluding VAT (range midpoint).
- Weight reported by the author
- 26 g
- Print time reported by the author
- 2.92 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A Temperature Tower designed to find the correct temperature for your filament!
- Rating
- 4.826 / 5
- Likes
- 4,711
- Downloads
- 85,147
- Makes
- 300
- Views
- 252,202
- Reviews
- 298
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Share Alike
A Temperature Tower designed to find the correct temperature for your filament!
The included .gcode is sliced using Simplify3D with the "Multiple Processes" tool to set the temperatures at different layer heights. Take a look at the included image. Most settings for the S3D profile (0.15mm OPTIMAL) are from the official Prusa homepage.
NOTE: ONLY USE THE GCODE IF YOU ARE RUNNING AN ORIGINAL PRUSA i3 MK3/S!
Happy printing. :-)
Changelog:
Added version without numbers in case someone wants to use this tower for other materials
Added picture with measurements
Added .gcode for PETG
Print instructions
PLA G-Code:
File: temp-tower-190-230.stl
Base prints with 200°C
Bed 60°C
Sections print between 190 - 230 in 5°C increments
0.15 Optimal (PLA) Profile from official prusa homepage
Sliced with Simplify3D
PETG G-Code:
File: temp-tower-no-numbers.stl
Base prints with 240°C
Bed 90°C
Sections print between 220 - 260 in 5°C increments
0.15 Optimal (PETG) Profile from official prusa homepage
Sliced with Simplify3D
Attention!!!
Watch the first few minutes of the print. Especially when the lowest temperature sections starts. If the extruder cloggs up, create your own gcode and start with a higher temperature.