cycle2charge mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mounting adapter for a cycle2charge USB charger.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 28
- Makes
- 0
- Views
- 329
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Share Alike
Background
I bought a cycle2charge USB charger to run from the dynamo of my bike. I bought the handlebar mount for 22mm handlebars - but my handlebars are much bigger towards the stem which is where I wanted to mount the charger.
I have plenty of old mounting brackets from lights etc that came with spares or that have since died. I designed this model to attach the charger to an old Cateye light mount from this collection. Any similar mounting bracket will do though the design assumes one that mates with an M5 bolt.
Design
I made this mount in two parts so it can be printed without supports. I recommend printing the parts sequentially.
Orientation
I think the charger needs to be mounted the right way top to minimise water ingress which stops just using a bolt and some nuts as spacers.
Tube
There is a tube with only 0,75mm width walls but most modern printers can handle that OK.
The tube is there to stop the charger from wobbling on the bolt (charger was design for an M6 bolt but my light bracket needed an M5). It also stops the charger from spinning once mounted by connecting firmly to the bolt which is, in turn, connected to the light bracket.
This tube should be wide enough to let the M5 bolt pass through, but small enough that the bolt bites, so as to help prevent the charger from spinning once mounted. You may want to play with the inner size of the tube given your printers accuracy to find the sweet spot for you. The Fusion 360 design is attached and this can be tweaked with the bolt_hole_diam user parameter.
I still have an earlier draft of this piece fitted to my bike. In this earlier version the tube is only 5mm across internally (in the attached version it is 5,25mm). The M5 bolt was hard to screw through and the tube was deformed in the process - but once assembled it works well.
The hole in the charger the tube should fit through is 6mm so if you make the inner tube diameter too big the walls will get too thin. Removing the tube altogether is an option though.
Assembly
Use an M5 bolt. Screw it through the flat disc from underneath, the non tube side. Be careful not to brake the thin tube walls. Once the bolt is all the way through place the separate tube on top to act as a spacer. Then screw the bolt into the handlebar bracket.
USB Charger:
https://cycle2charge.de/index.php/en/