Voron Trident PUG (Parametric Umbilical Gland) Attachment for A/B drive
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Allows you to use the PUG printed umbilical and route your wires through the standard path/slot in the Trident A drive
- Rating
- 5 / 5
- Likes
- 61
- Downloads
- 327
- Makes
- 4
- Views
- 2,880
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- GNU General Public License v3.0
Since I am a poor grad student buying umbilical glands after a voron kit was just too much. Also, I had already connected my wires to the board, so I wasn't about to undo those million zipties to re-route them through a gland. Enter PUG- its fantastic since it is printed and the two halves can assemble on already routed wires.
Allows you to use the PUG printed umbilical and route your wires through the standard path/slot in the Trident A drive- the other files I found had it go to a different spot- where I think CAN users usually go. I like this better
Installation
BOM - 2x m3x12 BHSC
Follow the directions on the model I remixed- essentially take your two attachment Pug holders, install them with one screw (through the rounded side) into the drive mount. Then assemble your PUG, insert it into this drive mount, close the attachment holders and secure with a second screw.