Jersey Jack Pinball - Pirates of the Caribbean right ramp support
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Custom support for the right ramp. This fixes an issue where the left side can droop and as such a ball can become…
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 16
- Makes
- 0
- Views
- 380
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Custom support for the right ramp.
This fixes an issue where the left side can droop and as such a ball can become caught in this position and require removal of the glass to fix.
All of this is at your own risk! This is not a jersey jack approved solution. If in doubt about the design or your own skills do not do it and contact jjp support directly for help with the issue. ====================================================================================================================================================================================================
All the below assumes you have some mechanical ability and understanding to not break something.
Right then ...
two versions (see picture)
v16 (the one I am using)
short v16. This has a shorter hex spacer section. This allows you to put extra washers below my support to make it even higher. It is made shorter so that there is space between the top of my support and the screw head/rubber washer.
Put an extra washers BELOW my support IF you need to lift the left side even higher! Adding them to the top wont do anything ;)
Printing
100% infill as some parts need to be quite thin.
Should be strong enough.
Only printed at 0.4mm as the part is hidden so surface quality is not a concern.
Important Install instructions!
Remove the rear pearl motion bracket so it moves freely. You need to do this so you can test that nothing touches the support.
Do not just crank all your screws down! Check the support every time you tighten a screw.
You do not want to crack your ramp by over tightening something!
The support fits over the existing hex spacer/stand off.
Gently screw down both lower ramp screws so they are about half way in and start screwing down the main upper right screw just so it is held.
Check for space between ramp and support.
Make sure the very left of the support is sitting in the little corner with the metal bracket and opto.
You may have to hold the ramp in a nice position so it holds. Once again be careful you don't put too much pressure on any installed screws. A cracked ramp is something I don't want you to get!
Make sure you've slid the ramp it as far forward on the right screw metal so that it is as close to the black pearl as you prefer.
Check for space between ramp and support and make sure it is in a good position.
Screw lower screws in until just stopping the ramp from lifting off.
Screw right side down again until it starts squeezing the rubber washer.
Check for space between ramp and support.
Pictures i've attached show that there is very little gap between the ramp and the ship now.
Use a right angle or a ruler to check that it is close.
Double check that nothing touches the black pearl!
*Post-it note used to show the true surface of the ramp as the transparency in the ramp makes it hard to show that there isn't a gap.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.4
Infill:
100%
Category: Mechanical Toys