Lukisegler-NG XS e mini RC-glider (Update to brushless electric drive)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Update of the Lukisegler-NG XS mini RC-glider to brushless electric drive
- Rating
- 0 / 5
- Likes
- 42
- Downloads
- 240
- Makes
- 0
- Views
- 2,581
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Lukisegler-NG XS e, Update to brushless electric drive
- Wingspan: approx. 900 mm
- Fuselage length: approx. 500 mm
- Take-off weight (LW-PLA): approx. 120 g
- Controls: elevator / aileron / motor
- Center of gravity: 8 mm behind the profile nose
- Rudder deflections: aileron 15-25°, EXPO-setting: -10% for direct respond
elevator: 10°, EXPO-setting: 20% - Motor: BETAFPV 1103 11000KV Brushless Motor
- ESC: 12A brushless-ESC
- Propeller: 65mm diameter (drone propeller)
- Battery: 2s Lipo 250 mAh

I have updated the Lukisegler-NG XS with a brushless electrical drive.
ATTENTION! Never run the brushless motor without load on full throttle! If the ESC does not catch the right communtation time the motor can be damaged from overcurrent!
I have also added a cowling and a spinner for the propeller.
The cowling is glued to the fuselage and adjusted to the height of the motor.
The spinner is plugged onto the motor axis. Then the propeller is attached on the axis.
The bulkhead is optimized for low weight (it is different from the version shown in the build-video).
If you decide to build the model, I would appreciate a short report on your experience in the comments or you can contact me via the prusaprinter messenger.
This would help me a lot to improve the design my new models or to fix errors in the actual models.