1 / 5
Calibration Cube v1 to test a lot of Stuff — image 1
1 / 5

Calibration Cube v1 to test a lot of Stuff

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

calibration cube with a lot of useful settings... The cube is 20x20x20mm - test e-Steps, angles, bridges, retract, flow

Rating
0 / 5
Likes
8
Downloads
167
Makes
0
Views
486
Reviews
0

Updated at source:

Model information

Category
Test Models
License
Creative Commons — Attribution — Noncommercial

This is my calibration Cube with a lot of useful settings. The Cube is 20x20x20mm. So you can test your e-Steps, Angles, Bridges, Retract and Flow with one Print.

  1. On the Front you can find the Angle Test with 40, 50 and 60 Degrees. There is also a Hole that should be 5mm in Diameter after printing. 
  2. On the Top  you can see the Bridge Test with 3 to 15mm Bridges. 
  3. The Shells on the left-, right- and back-side are set up to 0.4mm. So these Shells are printed with only one Shell to measure the flow (optimized for 0.4mm nozzle). 
  4. On the Backside you can find a cut out and inside the retract tower. These Parts are used for the retract test.
  5. On the Left is a small overhang with 1mm. It should be a Hexagon after printing.

If all setup correctly on your printer, the print should come out quite nice.

Print settings:

  • 0.4mm nozzle
  • 0.2 layer
  • no support
  • Resolution: 0.2
  • Infill: 12%
  • printtime 12-15min

Tags