1 / 5
Calibration Cube v1 to test a lot of Stuff
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
calibration cube with a lot of useful settings... The cube is 20x20x20mm - test e-Steps, angles, bridges, retract, flow
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 167
- Wydruki
- 0
- Wyświetlenia
- 486
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Noncommercial
This is my calibration Cube with a lot of useful settings. The Cube is 20x20x20mm. So you can test your e-Steps, Angles, Bridges, Retract and Flow with one Print.
- On the Front you can find the Angle Test with 40, 50 and 60 Degrees. There is also a Hole that should be 5mm in Diameter after printing.
- On the Top you can see the Bridge Test with 3 to 15mm Bridges.
- The Shells on the left-, right- and back-side are set up to 0.4mm. So these Shells are printed with only one Shell to measure the flow (optimized for 0.4mm nozzle).
- On the Backside you can find a cut out and inside the retract tower. These Parts are used for the retract test.
- On the Left is a small overhang with 1mm. It should be a Hexagon after printing.
If all setup correctly on your printer, the print should come out quite nice.
Print settings:
- 0.4mm nozzle
- 0.2 layer
- no support
- Resolution: 0.2
- Infill: 12%
- printtime 12-15min