1 / 1
Anycubic Kossel Linear Plus Magnetic Arms Alignment jig
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Delta magnetic arms length jig
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 14
- Makes
- 0
- Views
- 293
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
As the carbon rods are very difficult to saw to the EXACT same length, this jig helps you to align each pair of carbon rods to be the same length.
Instructions:
- Screw the 20mm set screws into the steel balls
- Cut the rods to rough length (preferably about 1mm shorter than the suggested 257mm)
- Put 2K epoxy in each end of the carbon tubes
- Stick 4 of the set screws with the steel balls into the rods ends
- Insert 2 rods into this jig
- Let the epoxy dry
- repeat 2 times
This will ensure that the needed length of the rods (267mm from center to center of the steel balls) is always on point.