Model Rocket Raspberry Pi & Camera Cage
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
For holding a Raspberry Pi Nano & battery assembly in the nose end of a model rocket, with a 50mm internal diameter.
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 46
- Makes
- 0
- Views
- 657
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
Mounting system for a Raspberry Pi Nano, and some extra electronics including a gyro/imu.
Fits a 50mm internal diameter tube. I use a drain pipe and a wrapping method to make mine.
Assembly is a little fiddly.
- Mount the battery on the reverse side of the top part of the mount.
- Assemble the bottom part onto the top using the alignment rings.
- Fiddle the battery into place on the bottom part of the mount.
- Super glue the nose cone onto the top part of the mount using the alignment rings.
- Insert the raspberry pi onto the top of the battery screws and tighten up.
The camera is pitched slightly upwards at an angle to give a better view in flight, instead of half of the frame being filled with a rocket. This can be adjusted as desired.
Best printed using a resin printer - I've never tried with FDM. I use light supports with a high-ish density of about 60% and add more supports where I feel necessary. As it's heavily dependent on printer and resin type YMMV.
Parts list
- Raspberry Pi nano
- Nano UPS backpack
- (optional) GY91 IMU (MPU9050 9axis)
- (optional) OV5647 Pi Camera