1 / 2
Model Rocket Raspberry Pi & Camera Cage — zdjęcie 1
1 / 2

Model Rocket Raspberry Pi & Camera Cage

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

For holding a Raspberry Pi Nano & battery assembly in the nose end of a model rocket, with a 50mm internal diameter.

Ocena
0 / 5
Polubienia
14
Pobrania
46
Wydruki
0
Wyświetlenia
657
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution

Mounting system for a Raspberry Pi Nano, and some extra electronics including a gyro/imu. 

Fits a 50mm internal diameter tube. I use a drain pipe and a wrapping method to make mine. 

Assembly is a little fiddly.

  1. Mount the battery on the reverse side of the top part of the mount.
  2. Assemble the bottom part onto the top using the alignment rings.
  3. Fiddle the battery into place on the bottom part of the mount.
  4. Super glue the nose cone onto the top part of the mount using the alignment rings.
  5. Insert the raspberry pi onto the top of the battery screws and tighten up. 

The camera is pitched slightly upwards at an angle to give a better view in flight, instead of half of the frame being filled with a rocket. This can be adjusted as desired.

Best printed using a resin printer - I've never tried with FDM. I use light supports with a high-ish density of about 60% and add more supports where I feel necessary. As it's heavily dependent on printer and resin type YMMV. 
 

Parts list

 

Tagi