1 / 2
Upgraded: Foldable Tablet / Phone Stand - No Screws — image 1
1 / 2

Upgraded: Foldable Tablet / Phone Stand - No Screws

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Easy to print phone stand upgraded for charging and holding phones horizontally.

Rating
5 / 5
Likes
39
Downloads
181
Makes
1
Views
1,257
Reviews
1

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial

Small upgrade of the original design:
+ phone is held higher, so there is a place for charging cable,
+ smaller phones have additional support in the middle to hold in vertical position,
+ there is a longer bar at the bottom to hold phones better,
+ the bar is separated at the center so that it's easy to put a charging cable.
- takes a little more printing time and filament.

Design is not print-in place, but in 3 parts - so absolutely easy to print.

In the pack the are 2 versions:
Small - with original Bottom and Arm parts and edited Hook,
Big - with longer edited Hook and expanded Bottom and Arm.
Small is recommended unless you need a book / notebook holder.

TO DO later (if needed):
Big version allows only more vertical positions. I will maybe later move arm fixing in big hook part higher, so that it allows more position adjustment and would use the shorter arm part.

Infill: 30%, cubic
Material: PLA
"Hook" parts require supports with "connected to bed" (not much of them).
"Bottom" parts print best with just a brim for better adhesion, so that parts do not separate during printing.

I'm posting with the same license as the original design from Mike-vom-Mars that is linked.

Tags