1 / 2
Upgraded: Foldable Tablet / Phone Stand - No Screws — zdjęcie 1
1 / 2

Upgraded: Foldable Tablet / Phone Stand - No Screws

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Easy to print phone stand upgraded for charging and holding phones horizontally.

Ocena
5 / 5
Polubienia
39
Pobrania
181
Wydruki
1
Wyświetlenia
1257
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

Small upgrade of the original design:
+ phone is held higher, so there is a place for charging cable,
+ smaller phones have additional support in the middle to hold in vertical position,
+ there is a longer bar at the bottom to hold phones better,
+ the bar is separated at the center so that it's easy to put a charging cable.
- takes a little more printing time and filament.

Design is not print-in place, but in 3 parts - so absolutely easy to print.

In the pack the are 2 versions:
Small - with original Bottom and Arm parts and edited Hook,
Big - with longer edited Hook and expanded Bottom and Arm.
Small is recommended unless you need a book / notebook holder.

TO DO later (if needed):
Big version allows only more vertical positions. I will maybe later move arm fixing in big hook part higher, so that it allows more position adjustment and would use the shorter arm part.

Infill: 30%, cubic
Material: PLA
"Hook" parts require supports with "connected to bed" (not much of them).
"Bottom" parts print best with just a brim for better adhesion, so that parts do not separate during printing.

I'm posting with the same license as the original design from Mike-vom-Mars that is linked.

Tagi